Custom Vac Logo
904 29 Avenue Nisku, AB.

Straight Vacuum Trucks


CV Line of Top Quality Vacuum Equipment

Semi Vac 17 Cube - TC 407/412

Featured - Straight Vac (unit displayed)

17 Cube - TC 407/412 and CSA B620-09

  • 17 Cubes 3740 Imp Gal +3% Outage
  • Full opening hydraulic rear door,Hoist cylinder and Vibrator
  • Full length subframe c/w Aluminum side deck/fender assembly, rear skirt and bumper
  • Robuschi RB-DV-85 PD High efficiency tri-lobe design Blower
  • 6" Plumbing, 6" Cyclone with clean-out door & heated drain valve
  • 6" brass load valve with 6" sandpipe D/S
  • Steel Vertical , deck cabinets & fitting boxes
  • D O T Lighting as required c/w L.E.D. work lights

Certified and Registered

Each design has been certified and registered with Transport Canada. This insure that all of the required specification have been achieved and are maintain though out the design and assembly process.

Contact Sales

For more information about customization contact our sales representative.

Units Available

See our online listing of unit immediately available and in production.

Standard Configuration 17 Cube Straight Vac


Custom Vac CV85 Vacuum System (Tri-Drive Mounted).

Design:  Vessel designed and constructed in compliance to Transport Canada TC407/412 CSA B620-09

Debris Tank (17 Cubes 3740 Imp Gal +3% Outage):

78 Diameter x 17"
Long 78" x 5/16
Heads 78" x 5/16" Shells
  • Four reinforcement rings
  • Three Rollover Bars
  • Tank Lock down assembly to meet current B620 Code
  • Reinforcing pads on all tank attachments
  • Pressure Vessel Hydro-tested to 40 PSI
  • Operating Temperature -20 deg F to 200 deg F
  • 3" x 30# PSIG Pressure Relief Vent  
  • Preformed angle pedestals
  • Prep Tank for Gallup Agitator
  • 8: heavy duty internal shut-off c/w 6" stainless steel floatball/cage and rubber seat and 6" flanged outlet
  • 6" Plumbing
  • Two 2" PRV'S in lower suction pipe
  • 6" Composite Loop Hose Vic Clamped
  • One Bolted Baffle
  • Full Opening Hydraulic Lift Rear Door with Safety Device c/w 6 pinwheel door locks
  • Rear door safety post P/S
  • 6" Brass Load Valve with 6" Sandpipe D/S
  • 4" Brass Load Valve P/S
  • 6" Brass Discharge Valve - Bottom Center of Rear Door
  • All rear valves heated and equipped with air/open, spring/close air actuators, separate flipper style control switches & aluminum camlocks
  • Recessed Stainless Steel Liquid Level Indicator - Grab Handle Style D/S
  • 6" Isolation Butterfly Valve - Air Control Switch at Operator Station
  • 6" Dip Port with Aluminum Camlock
  • 6" Cyclone with Clean-Out Door & Heated Drain Valve

Robuschi RB-DV-85 PD Vacuum Blower:

  • High Efficiency Tri-Lobe Design
  • 1600 CFM Free Air Rating
  • 27" Hg Maximum Vacuum
  • Oil Free Operation (Except Sealed Reservoirs)
  • Blower Clearance & Timing Inspection Prior to Installation
  • 6" Four-Way Diverter Valve (Vacuum to Pressure Modes)
  • 6" Double Door Check Valve (To Prevent Blower Back Spin)
  • 16" Dia. x 20 Micron Rating (Washable) Pre-stage Blower Filter Approved Design
  • High Torque/High Temp Blower Drive Coupling with Flexible Insert
  • One Exhaust Silencer, One Intake Silencer

P T O:

  • 8-Bolt P.T.O. (Greaseable Shaft Seal)
  • Air Shift Control & Hour Meter in Control Box by Driver's Seat

Hydraulic System (Linde Closed Loop Design):

  • Hydraulic Pump (Direct Mount to PTO)
  • Hydraulic Motor (Direct Mount to Blower)
  • Multi-function Hydraulic Control Bank
  • Variable Speed Joystick, for Blower Operation
  • Torque control for vac pressure
  • 90 Imperial Gallon Hydraulic Oil Reservoir (Cleaned, Purged & Air Tested Prior to Installation) c/w (10 Micron) In tank Filter, Breather fill cap, Temperature & Level  Indicator and inspection hatch
  • Global Hydraulic Vibrator with Flow Control Valve
  • One 12 Volt  Oil Cooler
  • Mailhot 3-Stage Hydraulic Dump Cylinder
  • Double Acting Rear Door Hydraulic Cylinder with Safety Counter Balance Valve
  • Hydraulic Hose And Fittings As Required
Straight Vac Brochure

National and International Sales


Custom Vac Service Ltd. offers custom built industrial vacuum equipment manufactured at our modern facility located in Nisku Alberta. Custom Vac Service Ltd. has a large inventory of vacuum trucks in production, ready for pant and for immediate delivery as well as a large inventory of vacuum trucks for rent or lease. 

Custom Vac's offers top quality industrial vacuum equipment for local, national and international sales. Custom Vac Service Ltd. offers equipment for export to the United States, Mexico and South America and welcomes inquiries from international customers requiring high quality custom built vacuum trucks.

A representative is available to answer any questions you may have about renting, leasing or purchasing a Vacuum Truck.






24/7 Vacuum Truck Service Facilities

Transport Canada "Certified" ABSA Registered Facility

Parts - Service - Inspections - Sales - Rentals - Leasing

Tel. +1  780 955-9344

Cor Certification

Tel. +1 (780) 955-9344 Fax. +1 (780) 955-9343
904 29 Avenue Nisku, AB. Canada T9E 1B7
Copyright (c) 2016 Custom Vac Services Ltd. Terms of Use l Privacy Policy